Weight Training

Better performances can be the product of a number of factors. This product is primarily the outcome of efficient technique, the progression of speed and the maturing competitive attitude on a sound basis of general endurance, all round strength and general mobility. The development of all round strength is best achieved via circuit training and then progressing this through weight training.

How do we get stronger?

A muscle will only strengthen when forced to operate beyond its customary intensity (overload). Overload can be progressed by increasing the:

• resistance e.g. adding 10kg to the barbell
• number of repetitions with a particular weight
• number of sets of the exercise

Muscle Fibre Hypertrophy

Resistance training will increase the muscle size (hypertrophy). Muscle growth depends on the muscle fibre type activated and the pattern of recruitment. Muscle growth is due to one or more of the following adaptations:

• Increased contractile proteins (actin & myosin)
• Increased number of and size of myofibrils per muscle fibre
• Increased amounts of connective, tendinous & ligamentous tissues
• Increased enzymes and stored nutrients

Which weight training exercises?

The exercise must be specific to the type of strength required, and is therefore related to the particular demands of the event (specificity). The coach should have knowledge of the predominant types of muscular activity associated with the particular event, the movement pattern involved and the type of strength required. Exercises should be identified that will produce the desired development. Although specificity is important, it is necessary in every schedule to include exercises of a general nature - e.g.

• Power Clean
• Power Snatch
• Bench Press
• Back Squats
• Sit Ups
• Deadlift
• Shoulder Press
• Chest Press
• Lat Pull downs
• Lower Back Extensions
• Tricep Press
• Calf Raise
• Bicep Curls
• Leg Curls
• Leg Extension
• Leg Press

These general exercises give a balanced development, and provide a strong base upon which highly specific exercise can be built.

Muscle Movement

Muscle contraction is initiated by an electrical charge from the central nervous system. The exercise that causes the greatest amount of electrical activity within the muscle group will potential produce the greatest gains in mass and strength. Lorenzo Cornacchia conducted a series of Electromyographic (EMG) tests to determine which exercises generated a high level of stimulation with in each muscle group. The results were as follows:

Olympic Lifts

The Olympic Lifts are recommended exercises for inclusion in power and speed training programs. The objective of these exercises is to develop the large muscles of the body in an explosive action that requires the use of many joints and muscle groups in a coordinated movement. The Olympic Lifts comprise of the Clean & Jerk and the Snatch. The Power Snatch and Power Clean are auxiliary lifts that aid in the training of the Clean & Jerk and the Snatch.

• Power Clean
• Jerk
• Power Snatch

How Much?

The amount of weight to be used should be based on a percentage of the maximum amount of weight that can be lifted one time, generally referred to as one repetition maximum (1RM). The maximum number of repetitions performed before fatigue prohibits the completion of an additional repetition is a function of the weight used, referred to as repetition maximum (RM), and reflects the intensity of the exercise. A weight load that produces fatigue on the third repetition is termed a three repetition maximum (3RM) and corresponds to approximately 95% of the weight that could be lifted for 1RM.

For maximum results, athletes should train according to their genetic predisposition. An athlete with a greater proportion of slow twitch muscles would adapt better to endurance training and a muscular endurance program using more repetitions of a lighter weight. An athlete with a greater proportion of fast twitch muscles would benefit from sprint training and a muscular strength program using fewer repetitions of a heavier weight.

Load - Repetition Relationship

The strength training zone requires you to use loads in the range of 60% to 100% of 1RM. The relationship of percentage loads to number of repetitions (rounded up) to failure is as follows:

• 60% - 17 reps
• 65% - 14 reps
• 70% - 12 reps
• 75% - 10 reps
• 80% - 8 reps
• 85% - 6 reps
• 90% - 5 reps
• 95% - 3 reps
• 100% - 1 rep

How Many

The number of repetitions performed to fatigue is an important consideration in designing a strength training program. The greatest strength gains appear to result from working with 4-6RM. Increasing this to 12-20RM favours the increase in muscle endurance and mass.

One set of 4-6RM performed 3 days a week is a typical strength training program. The optimal number of sets of an exercise to develop muscle strength remains controversial. In a number of studies comparing multiple set programs to produce greater strength gains than a single set, the majority of studies indicate that there is not a significant difference.

Handling heavy weights in the pursuit of strength will require a recovery of 3-5 minutes between sets, but only minimum recovery should be taken if strength endurance is the aim. The majority of athletic events are fast and dynamic, and therefore this quality must be reflected in the athlete's strength work.

Muscular strength is primarily developed when 8RM or less is used in a set. How much load you use depends upon what it is you wish to develop:

• 1RM to 3RM - neuromuscular strength
• 4RM to 6RM - maximum strength by stimulating muscle hypertrophy
• 6RM to 12RM - muscle size (hypertrophy) with moderate gains in strength (Fleck & Kraemer, 1996)
• 12RM to 20RM - muscle size and endurance

Rest Interval between sets

The aim of the recovery period between sets is to replenish the stores of ATP and Creatine Phosphate (CP) in the muscles. An inadequate recovery means more reliance on the Lactic Acid (LA) energy pathway in the next set. Several factors influence the recovery period, including:

• Type of strength you are developing
• The load used in the exercise
• Number of muscle groups used in the exercise
• Your condition
• Your weight

A recovery of three to five minutes or longer will allow almost the complete restoration of ATP/CP.

Rest Interval between sessions

The energy source being used during the training session is probably the most important factor to consider. During the maximum strength phase, when you are primarily using the ATP/CP energy pathway, daily training is possible because ATP/CP restoration is completed within 24 hours. If you are training for muscular endurance (muscle definition) then you require a 48 hour recovery as this is how long it takes to fully restore your glycogen stores (Piehl, 1974; Fox et al, 1989).

As a 'rule of thumb' 48 hours should elapse between sessions. If training strenuously, any athlete will find it extremely difficult to maintain the same level of lifting at each session, and the total poundage lifted in each session would be better to be varied (e.g. a high, low and medium volume session) each week.

What sort of weight lifting equipment?

There are variable resistance machines and free weights. Variable resistance machines are effective tools for building strength and muscle tone and are designed to work the target muscle in isolation, without the assistance of the surrounding muscles. Free weights (barbells, dumbbells and machines that provide the same equal resistance to a muscle) allow you not only to target a particular muscle group but to engage other muscles that assist in the work. Once they are conditioned, these assisting muscles help you to increase the weight you use in training the target muscles in order to stimulate the most growth in muscle fibres. The assisting muscles help stabilize the body, support limbs and maintain posture during a lift. Lifting free weights improves your coordination by improving the neuromuscular pathways that connect your muscles to the central nervous system.

Training Systems

Simple Sets e.g. 3 x 8 with 70% - meaning three sets of eight repetitions with a weight of 70% of maximum for one repetition. All novice lifters should work on, because the high number of repetitions enables the lifter to learn correct technique, and thereby reduce the risk of injury this system.

Pyramid System Here the load is increased and the repetitions are reduced (e.g. 100kg x 10, 120kg x 5, 130kg x 4, 140kg x 3, 150kg x 2, 160kg x 1). Pyramid lifting is only for experienced lifters who have an established good technique.

Super Setting This consists of performing two or three exercises continuously, without rest in between sets, until all exercises have been performed. The normal 'between sets' rest is taken before the next circuit of exercises is commenced.

Training Programs

Use the above notes to assist you in the preparation of a general strength training program, to develop your general strength, and a specific strength training program to develop your specific strength to meet to the demands of your event/sport.

If weight training facilities is limited to your home and a set of dumbbells then it is still possible to construct a dumbbell weight training program.

To monitor progress in training you should conduct strength and muscle balance tests.

Weight Lifting Standards

Weight lifting standards are an indication of the maximum load or one repetition max (1RM) that you should be able to lift for a particular weight lifting exercise based on your gender, body weight and weight lifting experience.

Calculation Parameters

The calculator below, which is appropriate for an adult male in the weight range of 120-320lbs and an adult female in the weight range of 100-200lbs, provides an estimate of the maximum load (1RM) standard for the following weight lifting exercises:

• Military Press or Shoulder Press
• Bench Press
• Squat
• Deadlift
• Clean

Three estimates are provided:

1. Novice - an adult with less than 1 years experience of regular weight training
2. Experienced - an adult with 1 to 2 years experience of regular weight training
3. Advanced - an adult with more than 2 years experience of regular weight training

1RM standard

To view an estimate of the 1RM standard for a weight lifting exercise please enter your weight, select your gender and the weight lifting exercise and then select the '1RM Standard' button.

Weight lbs kgs	Gender Male Female	Lift Military Press Bench Press Squat Deadlift Clean
Novice	Experienced	Advanced
lbs	lbs	lbs
kgs	kgs	kgs

Safety in the Weight Room

Strength training is safe when properly supervised and controlled. Every weight room should have a set of rules and regulations pertaining to safety and they should be on public display. Rules may vary from one weight room to another but some very basic rules apply to them all:

• Train only when a qualified coach is present
• Follow your training schedule
• Work in pairs - one lifting the other spotting
• No horseplay
• Wear the correct clothing and shoes
• No eating, drinking or smoking
• No personal stereos with headphones
• Help and respect other athletes
• Only athletes who are working out should be in the weight room

Make sure you and your athletes are fully aware of the safety rules applying to the weight training room(s) you use.

Remember

Weight training requires supervision to ensure sound technique in pursuit of safety and efficiency.

Free Calculator

• % Load to Repetition relationship - a free Microsoft Excel spreadsheet that you can download and use on your computer.

Additional Information

Associated Pages

The following Sports Coach pages should be read in conjunction with this page:

• Articles on Strength training
• Circuit Training
• Strength Training
• Weight Training

Associated Web Sites

The following web sites contain more information related to this topic:

• Body Building Revealed
• Complete Olympic Lifting DVD
• Diet Supplements Revealed
• Dumbbell Routines and Exercises E-book
• Lifetime Strength
• Peak Performance Sports Science Library

Associated Books

The following books provide more information related to this topic:

• Explosive Power and Strength, D.A. Chu, ISBN 0 87322 643 7
• Strength Training Anatomy, F. Delavier, ISBN 0 7360 4185 0
• Strength Training for Athletes, A. Winch, ISBN 1 86126 650 2
• Serious Strength Training, T.O. Bompa et al., ISBN 0 88011 834 2
• Strength and Conditioning for Games Players, C. Brewer, ISBN 1 902523 85 7
• Strength Training for Coaches, B. Pauletto, ISBN 0 88011 371 5
• Advanced Studies in Physical Education and Sport, P Beashel et al., ISBN 0 17 4482345
• Physical Education and the Study of Sport, B. Davis et al., ISBN 0 7234 31752
• Essentials of Exercise Physiology, W.D. McArdle et al., ISBN 0 683 30507 7
• Physical Education and Sport Studies, D. Roscoe et al., ISBN 1 901424 20 0
• The World of Sport Examined, P. Beashel et al., ISBN 0 17 438719 9
• Advanced PE for Edexcel, F. Galligan et al., ISBN 0 435 50643 9
• Examining Physical Education, K. Bizley, ISBN 0 435 50660 9
• Sport and PE, K Wesson et al., ISBN 0 340 683821
• PE for you, J. Honeybourne, ISBN 0 7487 3277 2

Help

If you would like any further advice on this topic then please click here to email me your query.

Free `Sports Performance Bulletin`